Guide for Using DIRECTV® SWM Technology with Winegard® Mobile Satellite TV AntennasFor up-to-date information on receiver compatibility & programm
Wiring Version 2Set the Dish Type to 04: Slimline-5, and set the Switch Type to 01: SWM. For more information on receiver setup and complete step-by-s
DVR Receiver*Non-DVR Receiver*A/B Switch #2A/B Switch (75 ohm) SpecificationsFrequency Range (DC): 2250 MHzCurrentCapacity:≥2AIsolation: > 25 dB
Wiring Version 1All three ports of the SK-3003 TRAV’LER antenna must be connected as shown to three inputs on the SWM8 for access to 101° odd and even
Wiring Version 2All three ports of the SK-3003 TRAV’LER antenna must be connected as shown to three inputs on the SWM8 for access to 101° odd and even
For access to 101° satellite programming, connect the primary and secondary ports of the antenna (located behind the reflector) to both SWM inputs cor
The wiring diagram below applies to most portable dishes and tripod kits not already covered. The coaxial connection ports can be found at the base of
Receiver settings are listed below for Winegard antennas using SWM technology. For more information on receiver setup and complete step-by-step instru
Winegard mobile satellite TV antennas that operate with Multi-switch technology require separate accessories to operate with DIRECTV Single Wire Multi
Antennas Sat 99° Sat 101° Sat 103° Sat 110° Sat 119° Wiring diagramTRAV’LER SK-3005DIRECTV SlimlineSee page 3 for a SWM8 installation, pages 7–10 for
For access to 99°/101° and 103°/110°/119° satellite programming, connect all four ports of the SK-3005 TRAV’LER antenna to all four inputs on the SWM8
The wiring diagram below applies to all Winegard satellite TV antennas that require separate accessories to operate with SWM technology. This wiring s
The wiring diagram below applies to dome antennas, including the Carryout GM-1518 & GM-1599, Carryout G2, RoadTrip Mission & MiniMax, and Dura
If connecting to a DVR receiver, do not connect a coaxial cable to the Satellite 2 input. With SWM, only connect to the Satellite 1 port (labeled FTM
A/B Switch (75 ohm) SpecificationsFrequency Range (DC): 2250 MHz.CurrentCapacity:≥2AIsolation: > 25 dBInsertion Loss: < .25 dBReturnLoss:≥
Non-DVR Receiver*DC Power PassDVR Receiver*Terminate unused splitter outputs with a 75 ohm termination cap.If connecting to a DVR receiver, do not con
Kommentare zu diesen Handbüchern